The construction method of Swimming Pool Mosaic is as follows: 1. Check construction materials Before construction, carefully pack the artistic Mosaics in the boxes to see if there are enough mosaics to complete the work. On each box, we will display the product model, Color number, production batch number, and other details. 2. Level the ground foundation This step is to level the foundation of the ground, which must be smooth and of the same color. 3. Scribing Draw a line on the ground to record the exact position of each mosaic. Lay 3 tiles on the ground side by side, so that the mortar joint between tiles is the same as that in one tile. 4. Prepare special glue for Swimming Pool Prepare the special glue mixed in proportion for the swimming pool, and apply the tile glue with a trowel, but the applied area shall not exceed the area where nine mosaics are placed. First, use a trowel with smooth edges to smooth the tile adhesive, and then use a trowel with serrated edges to plaster a layer of uniform serrated stripes. Now, the mosaic is ready to be paved. 5. Pave and fix Because mosaics are all pasted with nets, they can be directly applied to the wall surface that has been coated with tile glue. Lay the mosaic vertically. Please note that the gap between pastes must be consistent with the mortar joint of each paste. 6. Reinforcement After each tile is positioned, tap the surface of the mosaic with a gray board to make it firmly stick to the wall. 7. Ensure consistent mortar joints After each tile is fixed, the gap between bricks must be determined as a uniform width before the placement of joint filler. In this way, it is necessary to adjust the mortar joint with a small mortar shovel. This is a process that requires the most patience in the process of laying mosaic, but the process of laying is the most important link. 8. Caulking agent Prepare the required sealant. Use a small mortar shovel, take a small amount of mixed joint sealant each time, and apply it evenly on the mosaic surface. The small mortar shovel should move diagonally, from bottom to top, and then from top to bottom, to ensure that all mortar joints can be completely filled and there is no surplus residue. 9. Cleaning Start to clean the surface of the mosaic before filling it with the agent. Prepare two buckets, one for new detergent and one for clean water. First, soak the cloth in the bucket containing detergent without wringing it dry, and then wipe the surface of the mosaic in a circular manner; Then soak the sponge in the second clean bucket, and then wipe the surface of the mosaic with the sponge to remove all residues. Finally, sponge the surface again until it is clean. The construction steps of the swimming pool mosaic may be a little cumbersome, but if you want this effect of the mosaic, you must not be afraid of trouble. In addition, some details must be handled well. Because it is a ceramic tile that forms a whole, we cannot make it too rough, and must form a particularly complete plane. If the swimming pool mosaic does not pay much attention to the details during construction, it may cause uneven tiles and greatly affect its effect. Swimming pool mosaics often use different blue small tiles, and the blue color will be different in depth.
Gong Loon Jadeite Manufacture Co.,Ltd
